News
The Prosperitas Protocols Trilogy is Live! There is a coupon code in the blog post! 50% off...
I am reworking the landing pages. I was not happy with how they looked. Now they will be more consistent and readable. Starting with the oldest products and working my way forward. It is a work in progress at:
https://games.akapplegarth.us
The Cult Engine is now Copper! You can find it HERE!
Check out the blog post to get a 10% off coupon!
Blog Post
It is on the way! Once I get the proof (if there are no more mistakes!), it will be going live soon. This book delves into what makes a memorable NPC. Structured towards the horror genre, but can be applied wider. Lets face it, we only remember a few NPCs, this book will tell you why and how to make your NPCs more memorable and get your players to care about them.
More to come.
You can find out more here: Game.AKApplegarth.us
My next title is almost done! Check it Where Madness Watches!
My latest scenario, The Chiaroscuro Descent, just made COPPER! Check it out here: The Chiaroscuro Descent
All done... Well, as good as it gets. I will start posting more stuff soon.
Home
More Updates
Just finished printing the last piece for my K2SO head project. Assembly should not take too long (actually, it took a lot longer than I thought - see the project page for more), but finishing will. There is about 20 hours of printing that went into this project. But I am not too happy with the fit of the top of the head. I am going to be reprinting the front, middle, and back to see if I can get a better fit and hopefully less time required to finish it. I added some pictures to the K2SO gallery so you can see.
I also did some work figuring out how I was going to integrate the RCWL-0516 module into my Talking Skull Project and it is going to be really simple. You only need 3 pins - power, ground and and output. When it detects an living object, it outputs 3.3v on the output pin. And by default, it has a range of ~7 meters. I may have an issue with the 360 degree detection though. The next part of the project is figuring out the sound level module and getting that working with the Arduino moving the jaw. Which actually turned out quite simple. I did order a MP3 player that will be triggered by the detector module. Once that gets in I can move forward on this project.
I do have the camera to put into InMoov's eye. I am just trying to figure out how to route the USB cable from they eye and out the neck. I am pretty sure I am going to need to disassemble InMoov again...
TTFN,
Keith